Guanxing Electronics - Enping Guanxing Electronics Factory site!

Guanxing Electronics - Enping Guanxing Electronics FactoryQuality            Guanxing Electronics - Enping Guanxing Electronics FactoryMaterials            Guanxing Electronics - Enping Guanxing Electronics FactoryService






    企业QQ :2853265911

    联系电话 :86-0750-7781218



    所在地址 :广东省恩平市侨兴街9号

    Maintenance items of the microphone.

    Maintenance items of the microphone.

    发布日期:2019-03-26 点击:


    Honestly, how should the microphone be maintained?

    The microphone affects the normal use of multimedia. Matters needing attention in its protection:

    1. Correctly install and disconnect the cable and microphone. Pierce the XLR plug (commonly known as the XLR head) into the microphone, rotate the plug to align the upper button with the groove on the microphone, and then push the plug into the microphone until the button is positioned; when the microphone is separated from the cable, you can hold it For the plug, press the buckle button together, and then pull the plug out of the microphone. Do not force the connection and separation operation without aligning or pressing the buckle.

    2. The "howling sound" of the microphone in use may be caused by the cover of the microphone head or the microphone being too close to the loudspeaker. The correct solution is: firstly lower the volume and place the same loudspeaker. Interval, try to prevent the microphone and the loudspeaker from facing each other, and then adjust the volume to an appropriate volume.

    3. The microphone is a kind of high-sensitivity audio equipment. It is necessary to pay attention to handle it gently to prevent it from falling from a height. Shocks may cause the sensitivity of the microphone to decrease or even be damaged.

    4. Do not blow into the microphone forcefully or tap its head with your hands to test the sound. The correct way to test the sound is to aim at the microphone and speak in a normal tone.

    5. The key push and pull of the microphone should be emphasized with moderate strength and push and pull in place. If it is found that there is a very loud noise during use, it may be formed because the key is not pushed and pulled in place or the touch is not good. The correct way is to push the switch from the beginning. If the touch is not good, repair it as soon as possible.

    6. The conference microphone or wireless microphone is not needed for a long time, and the battery should be removed and reinstalled when it is used. If the sound is intermittent during use, it may be caused by the lack of battery power, so replace the battery with a new one in time.

    7. When not in use, store the microphone in a dry and hygienic place to prevent storage and use in places with high temperature and humidity to avoid affecting the sensitivity and tone of the microphone.



        ● QQ :2853265911

        ● Phone :86-0750-7781218


        ● Address :9 Qiaoxing Street, Enping City, Guangdong Province

        ● Foreign managers:WuXianSheng :13025860630

        ● Domestic manager :YuXiaoJie :18026822165

        ● Domestic manager:LiuXianSheng :18026876191

        ● Technical Manager : Yang : 18026826391

        Copyright ©Maintenance items of the microphone.-恩平市冠星电子厂!粤ICP备2021042115号-1  

        Guanxing Electronics - Enping Guanxing Electronics Factory